Skull Head for Day of the Dead Sugar Skulls Mold – 67×50 mm


This piece was designed specifically to do the Sugar Type Skull designs on the face.  It measures 67x50mm at its widest points.  I would recommend pouring into this mold when your resin is just mixed especially down into the teeth area as its a tight area and will require you to wait until your piece is thoroughly cured before removing.  The teeth inside are quite thick but repeatedly removing especially when not totally cured may pull and thin the area.  I would recommend always keep something under your mold just in case there is a bit of seepage at some point (that goes with all molds though).   The teeth mold up different every time.

There will be some “water marks” (or air pocket marks) in this mold.

This piece is designed from start to finish by me and is not to be remolded or a blank sent to someone else to remold.

All my mold designs have been tested by me before I offer them for sale and only sell what I would personally use myself.  They are made from the same style plastic as offered by the major brands for easy release of resin.  Each individual mold is handmade by me.

To see the molds in living color, check out the video below:

In stock

SKU: 1027 Category: Tags: , , , , ,







There are no reviews yet.

Be the first to review “Skull Head for Day of the Dead Sugar Skulls Mold – 67×50 mm”

Your email address will not be published. Required fields are marked *

Pin It on Pinterest